Kelvinator Appliance Repair Montreal
Expert service for Kelvinator kitchen and laundry (many share Electrolux/Frigidaire platforms). We stock common parts, provide clear estimates in-home, and back repairs with a one-year parts & labour warranty.
Expert service for Kelvinator kitchen and laundry (many share Electrolux/Frigidaire platforms). We stock common parts, provide clear estimates in-home, and back repairs with a one-year parts & labour warranty.
Our technicians are trained to focus on certain brands to improve efficiency
Give us a call, we will send a professional repairman to your home that specializes on your brand.
Kelvinator Residential or Commercial appliances.
Flash Repair
We repair Kelvinator refrigerators & freezers, dishwashers, ranges/ovens, and legacy laundry units. Because many models share Electrolux/Frigidaire architecture, parts availability is strong and diagnosis is efficient. You’ll get an upfront quote before work begins and full testing after the repair.
| Fault/Code | Condition/Description | Solution |
|---|---|---|
| i10 / E11 | Low/no water fill | Open supply; clean inlet screen; test fill valve & flow meter. |
| i20 / E21 | Drain time exceeded / restriction | Clean filter/air gap/hoses; test drain pump. |
| i30 / E13 | Leak detected / base float active | Dry pan; locate and correct leak; reset float. |
| i50 / E52 | Wash/circulation motor or triac fault | Test motor windings/triac; replace pump or board. |
| i60 / E61 | Heating fault / no temp rise | Ohm element/NTC; inspect relay; replace failed part. |
| ER / UO | Vent or fan error (select) | Test vent motor; replace if seized. |
| CL | Control lock engaged | Unlock per console legend; verify UI. |
| PF | Power failure during cycle | Clear fault; verify circuit & connections. |
| iF0 | Overflow/overfill protection | Check pressure sensor/tube; inlet valve stuck closed. |
| iC0 | Control fault (service) | Power reset; replace control if persistent. |
| Fault/Code | Condition/Description | Solution |
|---|---|---|
| F10 | Runaway temperature | Check RTD (~1080Ω @ 70°F) and stuck relays; replace sensor/control. |
| F30/F31 | Oven sensor open/short | Repair harness; replace RTD or board. |
| F90 | Door lock/latch error (self-clean) | Service lock motor & switches; replace latch assembly. |
| F11 | Keypad stuck / UI fault | Reseat ribbon; replace touch panel/UI. |
| F14 | Communication/EEPROM error | Power reset; replace control if persistent. |
| F43 | Cooling fan fault | Test tacho/fan; replace fan or relay board. |
| IGN | Ignition failure (gas) | Measure igniter current ≥3.2A; replace igniter/valve. |
| PF | Power failure | Clear and retest; verify neutral/ground. |
| Probe | Meat probe error | Replace probe/jack; verify board input. |
| LOC | Control lock active | Unlock per manual; verify keypad. |
| Fault/Code | Condition/Description | Solution |
|---|---|---|
| H / HI | High temperature alarm | Clean condenser; verify fan/compressor; sealed-system diagnostics. |
| dO | Door open / switch fault | Adjust hinges/level; replace switch or gasket. |
| SY CF | Control ⇄ UI communication fault | Reseat connectors; replace control/UI. |
| E0x | Sensor/NTC out of range | Ohm sensors; replace NTC or board. |
| DF | Defrost failure | Test heater/bi-metal/ADC; replace failed component. |
| FAN | Evaporator or condenser fan error | Replace motor; clear ice/debris; check tacho. |
| ICE | Icemaker harvest/fill fault | Run IM test; replace module/motor/valve. |
| INV/COMP | Inverter/compressor error | Test inverter DC & windings; replace inverter/compressor. |
| Filter | Water filter reminder | Replace filter; reset indicator. |
| PF | Power failure | Clear alarm; verify supply. |
| Fault/Code | Condition/Description | Solution |
|---|---|---|
| E11 | Fill time too long | Open valves; clean screens; replace inlet valve. |
| E21 | Drain timeout | Clear pump/hoses; replace drain pump if weak. |
| E41/E42 | Door/lock not engaged | Replace door lock assembly; check strike. |
| E52 | Motor tachometer signal fault | Test motor & hall; check belt; replace inverter/board. |
| E5A/E5E | Motor/inverter overheat/comm error | Verify cooling & harness; replace inverter. |
| E66 | Heater relay stuck | Replace control/relay; test element. |
| E68 | Heater leakage to ground | Megger element; replace if shorted. |
| EF3 | Leak detected (float) | Inspect hoses/boot; repair leaks; reset float. |
| Ub | Unbalance detected | Level; inspect shocks/suspension. |
| PF | Power failure | Clear; verify supply. |
| Fault/Code | Condition/Description | Solution |
|---|---|---|
| E64 | Heater open (electric) | Test/replace element; inspect relays. |
| E63 | Heater relay stuck | Replace control/relay; check wiring. |
| E71/E72 | Exhaust/inlet NTC out of range | Ohm thermistors; replace sensor/control. |
| E68 | Heater leakage to ground | Megger element; replace if shorted. |
| tS/tF | Thermistor short/open | Replace NTC or board channel. |
| AF | Restricted airflow | Clean vent/duct; verify blower & housing. |
| E5B | No heat overall (gas/electric) | Check igniter/valves or element/thermostats. |
| E41 | Door switch fault | Replace door switch/latch. |
| L2 | Low line voltage (electric) | Verify receptacle/breaker/terminal block. |
| PF | Power failure | Clear and retest; confirm supply. |
Monday to Friday
7:00am - 9:00pm
Saturday
10:00am - 5:00pm
Sunday
12:00am - 5:00pm