Crosley Appliance Repair Montreal
Specialized in-home Repair and Installation of Crosley appliances (often Whirlpool/GE-based platforms for parts and service).
Specialized in-home Repair and Installation of Crosley appliances (often Whirlpool/GE-based platforms for parts and service).
Our technicians are trained to focus on certain brands to improve efficiency
Give us a call, we will send a professional repairman to your home that specializes on your brand.
Crosley Residential or Commercial appliances.
Flash Repair
We service Crosley kitchen and laundry products across Montreal. Many models share platforms with major OEMs, which helps with parts availability and fast repairs. One-year parts & labour warranty on our work.
| Fault/Code | Condition/Description | Solution |
|---|---|---|
| F1/F1-E0 | Main control fault | Reset; inspect harness; replace EOC if code returns. |
| F2 | Runaway temperature | Test RTD sensor & relays; replace failed part. |
| F3/F4 | Sensor open/short | Ohm RTD ~1080Ω @ 70°F; replace if out of spec. |
| F9 | Door lock fault (self-clean) | Test latch motor/switch; repair or replace assembly. |
| Fault/Code | Condition/Description | Solution |
|---|---|---|
| F9-E1 | Drain problem | Clear knockout/high loop/hoses; test drain pump. |
| F8-E1 | Fill fault | Clean inlet screen; test valve & pressure. |
| F7-E1 | Heater not heating | Test element/NTC; inspect control relay. |
| F4-E3 | Wash motor not running | Check harness; replace circulation motor as needed. |
| Fault/Code | Condition/Description | Solution |
|---|---|---|
| PO | Power outage logged | Acknowledge; verify temps; monitor. |
| d | Door open | Adjust hinges; test switch/gasket. |
| E-sensor | Temp sensor out of range | Ohm sensors; replace NTC/control as needed. |
| Fault/Code | Condition/Description | Solution |
|---|---|---|
| F9-E1 | Long drain | Clear pump/hoses; replace drain pump if weak. |
| F8-E1 | Low/No fill | Open valves; clean screens; test inlet valve. |
| F5-E2 | Lid lock fault | Adjust strike; replace lock assembly. |
| F7-E1 | Shifter/speed sensor fault | Test actuator & wiring; replace actuator. |
| Fault/Code | Condition/Description | Solution |
|---|---|---|
| AF / F4-E3 | Restricted airflow | Clean vent/duct; check blower & exhaust thermistor. |
| L2 | Low line voltage (electric) | Check breaker/receptacle/terminal block. |
| F01 | Main control failure | Inspect for thermal events; replace control if confirmed. |
Monday to Friday
7:00am - 9:00pm
Saturday
10:00am - 5:00pm
Sunday
12:00am - 5:00pm