Huebsch Commercial Laundry Repair Montreal
Certified repair for Huebsch vended/OPL washers, washer-extractors and dryers. Coin-drop, card, networked controls. OEM parts, clear estimates, one-year parts & labour warranty.
Certified repair for Huebsch vended/OPL washers, washer-extractors and dryers. Coin-drop, card, networked controls. OEM parts, clear estimates, one-year parts & labour warranty.
Our technicians are trained to focus on certain brands to improve efficiency
Give us a call, we will send a professional repairman to your home that specializes on your brand.
Huebsch Residential or Commercial appliances.
Flash Repair
We service Huebsch top-load and front-load washers, single-load gas/electric dryers, stack dryers and stack washer/dryers. Technicians stock common Alliance/Huebsch parts (valves, pumps, locks, boards, belts, motors, igniters, sensors) for fast first-visit fixes. Transparent pricing and full operational testing after every repair.
| Fault/Code | Condition/Description | Solution |
|---|---|---|
| LF | Long fill / low water flow | Open supply; clean inlet screens; test hot/cold valves & pressure. |
| dO | Lid/door open at start or spin | Adjust strike; replace lid lock/switch; check harness. |
| dL | Lid lock failed | Replace lock assembly; inspect latch & wiring. |
| LE | Load error / out of balance | Level unit; inspect suspension; redistribute load. |
| dr | Drain timeout | Clear pump/hoses; replace pump if weak/noisy. |
| tS/tF | Thermistor short/open (select models) | Ohm NTC; replace sensor/control. |
| Err 65 | Motor fault / no tach | Test motor & speed sensor; inspect belt; replace inverter/control. |
| PS | Pressure switch fault | Check pressure hose for kinks/leaks; replace switch. |
| Com | Control communication error | Reseat connectors; replace UI/main PCB. |
| PF | Power failure | Clear; verify dedicated circuit. |
| Fault/Code | Condition/Description | Solution |
|---|---|---|
| Err 01 | Door lock error | Service lock motor/switches; replace assembly. |
| Err 02 | Water level / pressure fault | Check pressure hose & sensor; replace switch. |
| Err 03 | Drain timeout | Clear trap/hoses; service drain pump. |
| Err 04 | Fill valve fault | Test coils; replace valve; verify flow. |
| Err 05 | Motor/inverter fault | Test windings/IGBT; replace inverter or motor. |
| Err 06 | Out of balance / no reach speed | Inspect springs/shocks; redistribute; check bearings. |
| Err 07 | Heater/NTC fault (if equipped) | Ohm element & sensor; replace as needed. |
| Com | UI ⇄ control comms | Reseat harness; replace board/UI. |
| LE | Leak detected | Inspect hoses/door boot/pump; repair. |
| PF | Power fail | Clear; verify supply. |
| Fault/Code | Condition/Description | Solution |
|---|---|---|
| AF | Restricted airflow | Clean ducting; inspect blower & housing; verify makeup air. |
| tS/tF | Exhaust thermistor short/open | Ohm NTC; replace thermistor/control. |
| HE | No heat / heater fault | Check element or gas igniter/valve; thermostats & hi-limit. |
| dO | Door open / switch fault | Replace door switch; adjust strike. |
| Mtr | Motor failure / capacitor | Test motor & cap; replace as needed. |
| LE | Leakage to ground (elec) | Insulation test element; replace. |
| L2 | Low line voltage | Verify supply/breaker/receptacle. |
| Com | UI/control comms error | Reseat connectors; replace PCB. |
| PF | Power fail | Clear; confirm dedicated circuit. |
| LOC | Control lock active | Unlock per model procedure. |
| Fault/Code | Condition/Description | Solution |
|---|---|---|
| AF | Restricted airflow (either pocket) | Clean ducts; verify blower & seals. |
| tS/tF | Thermistor short/open | Replace NTC or board channel (upper/lower). |
| HE-U / HE-L | Heat fault upper/lower | Check element/ignition path; thermostats. |
| dO-U/L | Door open upper/lower | Replace switch/latch; adjust door. |
| Mtr-U/L | Motor failure upper/lower | Test motor/cap/relay; replace. |
| Com | Inter-board comms | Check harness between UI & base PCB. |
| PF | Power fail | Clear; confirm supply. |
| L2 | Low voltage (elec) | Verify feeder & breaker size. |
| LE | Ground fault (elec) | Insulation test; replace element. |
| LOC | Control lock | Unlock per service mode. |
| Fault/Code | Condition/Description | Solution |
|---|---|---|
| LF / dO / dL | Washer fill or lid faults | Clean screens; replace valves/locks; check pressure hose. |
| dr | Washer drain timeout | Clear pump/hoses; replace pump. |
| AF / tS/tF | Dryer airflow or thermistor fault | Clean vents; replace NTC/control. |
| HE | Dryer heat fault | Element/igniter/valves & thermostats checks. |
| Com | Inter-module comms (stack) | Inspect harness between UI/washer/dryer PCBs. |
| Mtr-W/D | Motor fault washer/dryer | Bench test; replace motor/cap/inverter. |
| LE | Cabinet leak (washer) | Inspect hoses/boot/tub; repair. |
| UB | Unbalance (washer) | Level, springs/shocks; basket/bearing check. |
| PF | Power failure | Clear; verify dedicated circuits. |
| LOC | Control lock active | Unlock per model; verify UI. |
Monday to Friday
7:00am - 9:00pm
Saturday
10:00am - 5:00pm
Sunday
12:00am - 5:00pm