Expert service for Westinghouse kitchen and laundry appliances (many share Electrolux/Frigidaire architecture). We stock common OEM parts, give upfront estimates, and back repairs with a one-year parts & labour warranty.
Our technicians are trained to focus on certain brands to improve efficiency
Give us a call, we will send a professional repairman to your home that specializes on your brand.
Westinghouse Residential or Commercial appliances.
Flash Repair
We diagnose Westinghouse units quickly by platform—identifying the correct parts and procedures whether the product uses Electrolux/Frigidaire electronics or legacy controls. After repair, we fully test operation and share preventive tips.
| Fault/Code | Condition/Description | Solution |
|---|---|---|
| i10 / E11 | No/low water fill | Open supply; clean inlet screen; test fill valve & flow meter. |
| i20 / E21 | Drain time exceeded / restriction | Clear filter/air gap/hoses; test drain pump. |
| i30 / E13 | Leak detected (base float) | Dry tray; correct leak; reset float. |
| i50 / E52 | Wash/circulation motor or triac fault | Test motor & board triac; replace as needed. |
| i60 / E61 | Heater not heating / low temp rise | Ohm element/NTC; inspect relay; replace failed part. |
| F2-E1/E2 | Stuck key / UI mismatch (Whirlpool-derived) | Clean keypad; reseat ribbon; replace UI/control. |
| C1/C2 (GE) | Drain/fill faults | Verify pump/valve, hose routing, air gap. |
| F9-E1 | Long drain | Clear obstruction; replace pump if weak. |
| PF | Power failure during cycle | Clear and retest; verify circuit. |
| CL | Control lock active | Unlock per console legend; verify UI. |
| Fault/Code | Condition/Description | Solution |
|---|---|---|
| F10 | Runaway temperature | Check RTD (~1080Ω @ 70°F) & relays; replace sensor/control. |
| F30/F31 | Oven sensor open/short | Repair harness; replace RTD or board. |
| F90 | Door lock/latch error (self-clean) | Service lock motor & switches; replace latch assembly. |
| F11 | Keypad stuck / UI fault | Reseat ribbon; replace touch panel/UI. |
| F14 | Communication/EEPROM error | Power reset; replace control if persistent. |
| F43 | Cooling fan fault | Test tacho/fan; replace fan or relay board. |
| IGN | Ignition failure (gas) | Measure igniter current ≥3.2A; replace igniter/valve. |
| PF | Power failure | Clear and retest; verify neutral/ground. |
| Probe | Meat probe error | Replace probe/jack; verify board input. |
| LOC | Control lock active | Unlock per manual; verify keypad. |
| Fault/Code | Condition/Description | Solution |
|---|---|---|
| H / HI | High temperature alarm | Clean condenser; verify fans/compressor; sealed-system diagnostics. |
| dO | Door open / switch fault | Adjust hinges; replace door switch/gasket. |
| SY CF | Control ⇄ UI communication fault | Reseat connectors; replace control/UI. |
| E0x | Sensor/NTC out of range | Ohm sensors; replace NTC or board. |
| DF | Defrost failure | Test heater/bi-metal/ADC; replace failed component. |
| FAN | Evaporator or condenser fan error | Replace motor; clear ice/debris; check tacho. |
| ICE | Icemaker harvest/fill fault | Run IM test; replace module/motor/valve. |
| INV/COMP | Inverter/compressor error | Test inverter DC & windings; replace inverter/compressor. |
| Filter | Water filter reminder | Replace filter; reset indicator. |
| PF | Power failure | Clear alarm; verify supply. |
| Fault/Code | Condition/Description | Solution |
|---|---|---|
| E11 | Fill time too long | Open valves; clean screens; replace inlet valve. |
| E21 | Drain timeout | Clear pump/hoses; replace drain pump if weak. |
| E41/E42 | Door/lock not engaged | Replace door lock assembly; check strike. |
| E52 | Motor tachometer signal fault | Test motor & hall; check belt; replace inverter/board. |
| E5A/E5E | Motor/inverter overheat/comm error | Verify cooling & harness; replace inverter. |
| E66 | Heater relay stuck | Replace control/relay; test element. |
| E68 | Heater leakage to ground | Megger element; replace if shorted. |
| EF3 | Leak detected (float) | Inspect hoses/boot; repair leaks; reset float. |
| Ub | Unbalance detected | Level; inspect shocks/suspension. |
| PF | Power failure | Clear; verify supply. |
| Fault/Code | Condition/Description | Solution |
|---|---|---|
| E64 | Heater open (electric) | Test/replace element; inspect relays. |
| E63 | Heater relay stuck | Replace control/relay; check wiring. |
| E71/E72 | Exhaust/inlet NTC out of range | Ohm thermistors; replace sensor/control. |
| E68 | Heater leakage to ground | Megger element; replace if shorted. |
| tS/tF | Thermistor short/open | Replace NTC or board channel. |
| AF | Restricted airflow | Clean vent/duct; verify blower & housing. |
| E5B | No heat overall (gas/electric) | Check igniter/valves or element/thermostats. |
| E41 | Door switch fault | Replace door switch/latch. |
| L2 | Low line voltage (electric) | Verify receptacle/breaker/terminal block. |
| PF | Power failure | Clear and retest; confirm supply. |
Monday to Friday
7:00am - 9:00pm
Saturday
10:00am - 5:00pm
Sunday
12:00am - 5:00pm